Drywall has a lot of advantages compared to plaster. It’s less difficult and much faster to install. Also, it’s much more affordable compared to plaster. Many individuals can easily install drywall on their own and can save a lot of money. While drywall installation is easy and simple, drywall installation should be done by professional drywall contractors Colorado Springs

File:Pine Grove Homes Ready For Drywall.jpg - Wikimedia Commons

The reason for this is that there are a couple of errors that DIY-ers end up making during the installation of the drywall that influences the appearance and integrity of the walls. Today, we are going to share with you how to fix these common drywall issues. 

Misaligned Holes for Electrical Sockets 

It’s very hard to perfectly cut aligned holes on a drywall sheet. It isn’t something a regular homeowner can easily do. In addition to that, you can’t go back once you do it. There are a lot of tips that you can utilize to guarantee that every hole is well in line. Misaligned holes look very ugly and unappealing. Hiring an expert is the ideal way to address this issue.  

Tight Joints 

Joints that are tightly secured is another common issue that happens during the drywall installation. It might not appear like a huge issue. However, it still is. There has to be a bit of a gap between the drywall panels. This will enable the natural contraction and expansion of the materials underneath. It can cause the panels to break whenever drywalls are tightly fitted.  

There isn’t any solution to this issue. During installation, you’ve got to ensure that you leave a gap between every panel. The ideal gap is around 1/8-inch. This will help you prevent the issue from happening.  

Screws Driven Too Far 

Another common issue during the installation of the drywall is that the screws or nails are driven too far. Because of this, they damage the wallboard’s paper surface. The screw loses its holding power after the surface of the paper is damaged. This makes it a huge issue.  

Directly drive the screw-head over the surface of the paper cover and offer it an additional ¼ or ½ turn to push the screw below the surface. This will ensure you do not end up driving the screws too far. Don’t attempt to get rid of it in case you puncture the paper accidentally. The reason for this is that it will only make the issue worse. Add another screw rather than getting rid of it.  

Over-Sanding of Drywall Paper 

A lot of DIY-ers do is vigorously sand the drywall panels to obtain an ideally smooth surface. If you do this, you might end up sanding into the paper tape or fiberglass that covers the surface or the seams of other drywall panels. This will damage the drywall’s integrity. Re-taping the seams is what a lot of them do to fix the problem. However, that should not be the case. 

If you want to avoid this issue, you need to hire a professional drywall contractor to sand your drywall and help you with the installation.